45188
1.INSTALL STEERING WHEEL PAD ATTACHING SCREW
Set the 2 steering wheel pad attaching screws.
84632
2.INSTALL CRUISE CONTROL MAIN SWITCH
Install the cruise control main switch with the 2 screws.
Install the wire harness.
45116
3.INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Attach the 3 guide pins and claw to install the switch with the 2 screws.
45116
4.INSTALL NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Attach the 3 guide pins and claw to install the switch with the 2 screws.
84250A
5.INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
Attach the 6 guide pins and 2 claws to install the steering pad switch assembly with the 4 screws.
6.ADJUST SPIRAL CABLE
45100
7.INSTALL STEERING WHEEL ASSEMBLY
Align the matchmarks on the steering wheel and steering main shaft.
| *a | Matchmark |
Install the steering wheel set nut.
45130
8.INSTALL STEERING PAD
45187
9.INSTALL LOWER NO. 3 STEERING WHEEL COVER
45186
10.INSTALL LOWER NO. 2 STEERING WHEEL COVER
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45130
12.INSPECT STEERING PAD
13.CHECK SRS WARNING LIGHT