Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235849 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE

a.
B166448

Attach the 3 claws and install the spiral cable with steering sensor.

NOTICE:

When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.



b.

Connect the connectors to the spiral cable with steering sensor.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 84306 4.ADJUST SPIRAL CABLE

a.
B166449

Check that the ignition switch is off.


b.

Check that the battery negative (-) terminal is disconnected.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Rotate the spiral cable with steering sensor counterclockwise slowly by hand until it feels firm.

NOTICE:

Do not turn the spiral cable with steering sensor by the airbag wire harness.



d.
B166450

Rotate the spiral cable with steering sensor clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable with spiral sensor by the airbag wire harness.


HINT:

The spiral cable with steering sensor will rotate approximately 2.5 turns to both the left and right from the center.



Hide 45100 5.INSTALL STEERING WHEEL ASSEMBLY

Hide 45187 7.INSTALL LOWER NO. 3 STEERING WHEEL COVER

Hide 45186 8.INSTALL LOWER NO. 2 STEERING WHEEL COVER

Hide 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 11.INSPECT SRS WARNING LIGHT