89341B
1.INSTALL NO. 2 ULTRASONIC SENSOR
Attach the 4 claws to install the No. 2 ultrasonic sensor as shown in the illustration.
No. 2 ultrasonic sensor direction is the same as the keyhole direction.
Do not damage the bumper with the protrusion when installing the No. 2 ultrasonic sensor.
| *a | No. 2 ultrasonic sensor direction | *b | Keyhole direction |
52119A
2.INSTALL FRONT BUMPER COVER
53932B
3.INSTALL FRONT END PANEL LH (w/o Headlight Cleaner System)
53931B
4.INSTALL FRONT END PANEL RH (w/o Headlight Cleaner System)
Use the same procedure as for the LH side.
53932B
5.INSTALL FRONT END PANEL LH (w/ Headlight Cleaner System)
53931B
6.INSTALL FRONT END PANEL RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
7. PREPARE VEHICLE FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light)
8. PREPARE FOR FOG LIGHT AIMING (w/ Fog Light)
9.INSPECT FOG LIGHT AIMING (w/ Fog Light)
10.ADJUST FOG LIGHT AIMING (w/ Fog Light)