Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235790 CLEARANCE WARNING ECU A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913B 3.REMOVE FRONT DOOR SCUFF PLATE RH

Hide 62111C 4.REMOVE COWL SIDE TRIM BOARD RH

Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55045A 9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Hide 82861 10.REMOVE NO. 1 ECU INTEGRATION BRACKET

a.
E191462

Disconnect the ECU connectors and detach the harness clamp.

NOTICE:

Do not apply excessive force to the wire harnesses.



b.

Remove the bolt, nut and No. 1 ECU integration bracket.


Hide 89340A 11.REMOVE CLEARANCE WARNING ECU ASSEMBLY

a.
E161797

Remove the 2 nuts and clearance warning ECU from the bracket.

NOTICE:
·

Avoid any impact to the clearance warning ECU.

·

Do not drop the ECU. If it is dropped, replace it with a new one.