Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM D

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


a.

Blind spot monitor system data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and to repair.




DIAGNOSIS FUNCTION


a.

The blind spot monitor system displays the blind spot monitor system warning on the multi-information display in the combination meter assembly to inform the driver that the system is unavailable either temporarily, or unavailable due to a malfunction.



MALFUNCTION HISTORY


HINT:

The malfunction history for the blind spot monitor sensor can be displayed and cleared.


a.

Confirm the malfunction history.

i.

Connect the Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the Techstream on.


iv.

Turn the blind spot monitor main switch (warning canceling assembly) on.


v.

Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History


vi.

Confirm the displayed malfunction history results.

HINT:
·

If "YES" is displayed, perform the inspections listed under "Inspection Procedure" for each item.

·

If "NO" is displayed, proceed to the next suspected area in the problem symptoms table (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE).



Malfunction History Chart
Item Description Inspection Procedure
History of Module Blockage History of instances in which blind spot monitor sensor could not perform detection properly due to snow on rear bumper, rain, etc.
·

Check whether a Toyota genuine bumper is installed

·

Check that there is no foreign matter adhering to the bumper

·

Check that there is no foreign matter between the sensor and the bumper


History of Low Voltage History of low supply voltage from battery to blind spot monitor sensor Power source circuit (See page (Click here))
History of High Voltage History of high supply voltage from battery to blind spot monitor sensor
History of Low Temperature History of low temperature for the blind spot monitor sensor Check the outside temperature
History of High Temperature History of high temperature for the blind spot monitor sensor



b.

Clear the malfunction history.

i.

Connect the Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the Techstream on.


iv.

Turn the blind spot monitor main switch (warning canceling assembly) on.


v.

Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History


vi.

Clear the BSM Master Abnormal History.