Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM T

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Symptom Suspected Area See page
System does not operate at all Proceed to "Power source circuit" (Click here)
Proceed to "Main switch circuit" (Click here)
Replace blind spot monitor sensor RH (Click here)
System cannot be turned off Proceed to "Main switch circuit" (Click here)
Replace blind spot monitor sensor RH (Click here)
Blind spot monitor indicator for the right side does not illuminate Blind spot monitor beam axis inspection (Click here)
Replace outer rear view mirror glass RH (Click here)
Replace outer rear view mirror assembly RH (Click here)
Replace blind spot monitor sensor RH (Click here)
Blind spot monitor indicator for the left side does not illuminate Blind spot monitor beam axis inspection (Click here)
Replace outer rear view mirror glass LH (Click here)
Replace outer rear view mirror assembly LH (Click here)
Replace blind spot monitor sensor LH (Click here)
Blind spot monitor indicator for the right side is constantly illuminated Blind spot monitor beam axis inspection (Click here)
Replace blind spot monitor sensor RH (Click here)
Blind spot monitor indicator for the left side is constantly illuminated Blind spot monitor beam axis inspection (Click here)
Replace blind spot monitor sensor LH (Click here)
Blind spot monitor indicator for the right side does not blink Refer to "Turn Signal Switch Circuit" in the Lighting (Ext) section (Click here)
Refer to "Turn Signal Switch Circuit" (Click here)
Replace blind spot monitor sensor RH (Click here)
Blind spot monitor indicator for the left side does not blink Refer to "Turn Signal Switch Circuit" in the Lighting (Ext) section (Click here)
Refer to "Turn Signal Switch Circuit" (Click here)
Replace blind spot monitor sensor LH (Click here)
Blind spot monitor indicator for the right side is constantly blinking Replace blind spot monitor sensor RH (Click here)
Blind spot monitor indicator for the left side is constantly blinking Replace blind spot monitor sensor LH (Click here)
Blind spot monitor system warning message in the multi-information display is constantly displayed Check the outside temperature -
Check whether a Toyota genuine bumper is installed -
Check that there is no foreign matter adhering to the bumper -
Check that there is no foreign matter between the sensor and the bumper -
Proceed to "Power Source Circuit" (Click here)
Replace blind spot monitor sensor RH (Click here)
Replace blind spot monitor sensor LH (Click here)
Replace combination meter assembly (Click here)
Blind spot monitor system warning message in the multi-information display does not display during initial check Proceed to "Power Source Circuit" (Click here)
Replace blind spot monitor sensor RH (Click here)
Replace blind spot monitor sensor LH (Click here)
Replace combination meter assembly (Click here)