The blind spot monitor sensor receives the steering angle signal from the steering angle sensor via CAN communication.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A47 | A fail flag is transmitted from the steering angle sensor. | ·
Steering angle sensor ·
Blind spot monitor sensor RH ·
Blind spot monitor sensor LH |
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the steering angle sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC is output from the blind spot monitor sensor RH | B |
| DTC is output from the blind spot monitor sensor LH | C |
A
B
C