Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABA  Blind Spot Monitor Slave Module Connection Incorrect  


DESCRIPTION

The blind spot monitor sensor LH stores this DTC when terminal No. 3 of the blind spot monitor sensor LH is not connected properly, or the blind spot monitor sensor is not installed on its correct side and the wire harness that is connected to the blind spot monitor main switch assembly (warning canceling switch assembly) is connected to terminal No. 3 of the blind spot sensor LH.

DTC Code DTC Detection Condition Trouble Area
C1ABA There is an open in the ground circuit (Terminal No. 3) of the blind spot monitor sensor LH for a specified period of time.
·

Harness or connector

·

Blind spot monitor sensor LH



WIRING DIAGRAM

E224406E07
2.26,2.49 2.698,2.667 0.438,0.177 10 false LGND 2.729,2.375 2.844,2.542 0.115,0.167 10 false 3 1.698,3.219 2.073,3.375 0.375,0.156 10 false O46 1.708,3.385 2.865,3.719 1.156,0.333 10 false Blind Spot Monitor Sensor LH 4.552,3.219 4.948,3.375 0.396,0.156 10 false P25 4.552,3.396 5.76,3.729 1.208,0.333 10 false Blind Spot Monitor Sensor RH 1.031,4.271 3.125,4.458 2.094,0.188 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

After completing this inspection procedure, make sure to clear DTCs.

·

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.



PROCEDURE

1.CONFIRM PART NUMBER AND IDENTIFICATION MARK
a.

Confirm whether the blind spot monitor sensors are installed to the correct side or not.

i.

Check if the part number and identification mark of the blind spot monitor sensor on the vehicle is correct.

OK:

The part number and identification mark is correct.





OK

2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BODY GROUND)

NG

INSTALL BLIND SPOT MONITOR SENSOR TO CORRECT SIDE

2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BODY GROUND)
a.

Disconnect the O46 blind spot monitor sensor LH connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
O46-3 (LGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
O46-3 (LGND) - Body ground Ignition switch ON Below 1 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR