Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U0232  Lost Communication with Blind Spot Monitor Slave Module  


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH judges that there is a communication problem with the blind spot monitor sensor LH.

DTC Code DTC Detection Condition Trouble Area
U0232 The blind spot monitor sensor RH cannot receive signals from the blind spot monitor sensor LH.
·

CAN communication system

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check for DTCs of the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

OK:

CAN communication system DTCs are not output.




OK

2.REPLACE BLIND SPOT MONITOR SENSOR LH

NG

2.REPLACE BLIND SPOT MONITOR SENSOR LH
a.


NEXT

3.RECHECK DTC
3.RECHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

END (BLIND SPOT MONITOR SENSOR LH IS DEFECTIVE)

NG