Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U0233  Lost Communication with Blind Spot Monitor Master Module  


DESCRIPTION

This DTC is stored when the blind spot monitor sensor assembly LH judges that there is a communication problem with the blind spot monitor sensor RH.

DTC Code DTC Detection Condition Trouble Area
U0233 The blind spot monitor sensor LH cannot receive signals from the blind spot monitor sensor RH.
·

CAN communication system

·

Blind spot monitor sensor RH

·

Blind spot monitor sensor LH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check for DTCs of the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

OK:

CAN communication system DTCs are not output.




OK

2.REPLACE BLIND SPOT MONITOR SENSOR RH

NG

2.REPLACE BLIND SPOT MONITOR SENSOR RH
a.


NEXT

3.RECHECK DTC
3.RECHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

END (BLIND SPOT MONITOR SENSOR RH IS DEFECTIVE)

NG