Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U1331  Software Incompatibility with Body Control Module "B"  


DESCRIPTION

This DTC is stored when the destination information of the main body ECU does not match the destination information stored in the blind spot monitor sensor.

DTC Code DTC Detection Condition Trouble Area
U1331 Destination information of the main body ECU and blind spot monitor sensor do not match.
·

Main body ECU (cowl side junction block LH)

·

Blind spot monitor sensor RH

·

Blind spot monitor sensor LH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CONFIRM PART NUMBER (MAIN BODY ECU)
a.

Check the main body ECU part number.

i.

Check if the part number of the main body ECU on the vehicle is correct.

OK:

The parts number is correct.





OK

2.CHECK DTC

NG

REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

2.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTC is output A
DTC is output from the blind spot monitor sensor RH B
DTC is output from the blind spot monitor sensor LH C



A

B

C