Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235848 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B1615/14  Front Airbag Sensor LH Malfunction  


DESCRIPTION

The front airbag sensor LH consists of the diagnostic circuit and the frontal deceleration sensor, etc.

If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.

DTC B1615/14 is stored when a malfunction is detected in the front airbag sensor LH circuit.

DTC Code Detection Condition Trouble Area
B1615/14 When one of following conditions is met:
·

Front airbag sensor LH malfunction

·

Center airbag sensor malfunction


·

Front airbag sensor LH

·

Center airbag sensor assembly



WIRING DIAGRAM

C162318E10
1.235,1.024 1.586,1.177 0.351,0.153 10 +SL 1.255,2.187 1.606,2.340 0.351,0.153 10 -SL 1.746,0.877 1.867,1.030 0.121,0.153 10 2 1.746,2.07 1.982,2.233 0.236,0.163 10 1 3.649,1.973 3.770,2.126 0.121,0.153 10 1 3.649,0.799 3.885,0.962 0.236,0.163 10 2 3.58,1.021 3.895,1.168 0.314,0.147 10 AH7 3.588,2.205 3.903,2.352 0.314,0.147 10 AH7 5.663,1.025 6.013,1.178 0.351,0.153 10 +SL 5.682,2.188 6.033,2.341 0.351,0.153 10 -SL 0.304,3.845 0.582,3.997 0.278,0.153 10 A2 0.304,4.013 1.849,4.176 1.545,0.163 10 Front Airbag Sensor LH 5.469,3.854 5.747,4.007 0.278,0.153 10 H56 5.469,4.022 6.834,4.186 1.365,0.163 10 Center Airbag Sensor 5.324,0.901 5.520,1.064 0.196,0.163 10 30 5.342,2.092 5.538,2.254 0.196,0.163 10 28

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



PROCEDURE

1.CHECK FRONT AIRBAG SENSOR LH
C158831E02
0.435,1.032 1.230,1.403 0.795,0.371 10 Front Airbag Sensor RH 1.896,1.376 2.795,1.692 0.899,0.316 10 Center Airbag Sensor

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.


c.

Interchange the front airbag sensor RH with LH and connect the connectors to them.


d.

Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.


e.

Turn the ignition switch to ON, and wait for at least 60 seconds.


f.

g.

Turn the ignition switch off.


h.

Turn the ignition switch to ON, and wait for at least 60 seconds.


i.

Check for DTCs (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC B1615/14 is output A
DTC B1610/13 is output B
DTC B1610/13 and B1615/14 are not output C

HINT:

Codes other than DTC B1610/13 and B1615/14 may be output at this time, but they are not related to this check.




C

A

B