Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235854 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


HINT:

Installation is in the reverse order of removal.

The procedure described below is for the LH side.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)

a.

Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).


Hide 71200S 4.REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)

a.

Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).


Hide 71812D 5.REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat)

Hide 89178A 6.REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)

a.
B194811

Disconnect the connector from the seat position airbag sensor.


b.

Using "TORX" socket wrench T30, remove the "TORX" screw and the seat position airbag sensor.


c.

Remove the seat slide position sensor protector from the seat position airbag sensor.


Hide 89178A 7.REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)

a.
B194812

Disconnect the connector from the seat position airbag sensor.


b.

Using "TORX" socket wrench T30, remove the "TORX" screw and the seat position airbag sensor.


c.

Remove the seat slide position sensor protector from the seat position airbag sensor.