Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Manual Seat)
RM27L0U _58 Vehicle Interior _049342 SEAT _0235876 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  DISASSEMBLY  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 89952 1.REMOVE OCCUPANT CLASSIFICATION ECU (for Front Passenger Side)

Hide 72459A 2.REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Driver Side)

a.
B190969E02
2.594,0.125 2.292,1.208 true 2.615,0.052 3.26,0.813 0.646,0.76 10 true Protective Tape

Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the vertical adjuster handle cap.


Hide 72495 3.REMOVE VERTICAL ADJUSTING HANDLE LH (for Driver Side)

a.
B190970

Remove the 2 screws and vertical adjusting handle.


Hide 72457 4.REMOVE VERTICAL SEAT ADJUSTER KNOB (for Driver Side)

a.
B190971E02
1.094,0.396 0.865,0.969 false 1.156,0.302 2.271,0.76 1.115,0.458 10 true Protective Tape

Using a screwdriver with its tip wrapped in protective tape, remove the snap ring and vertical seat adjuster knob.


Hide 72526 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Driver Side)

a.
B190972E01
1.696,1.664 2.706,1.827 1.010,0.163 10 Protective Tape 1.662,1.744 0.965,0.758 false

Lift the reclining adjuster release handle.


b.

Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.


Hide 72525A 6.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Front Passenger Side)

a.
B165802E01
0.24,1.659 1.273,1.824 1.033,0.165 10 Protective Tape 2.364,0.748 1.497,1.75 false

Lift the reclining adjuster release handle.


b.

Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.


Hide 71812D 7.REMOVE FRONT SEAT CUSHION SHIELD LH (for Driver Side)

a.
B190973

Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.


b.
B190974E01
2.512,0.082 2.617,0.236 0.105,0.154 10 1 1.083,1.202 1.187,1.356 0.105,0.154 10 2 1.749,1.013 1.854,1.167 0.105,0.154 10 2

Remove the 3 screws.


c.

Disengage the 3 claws in the order shown in the illustration, and then separate the front seat cushion shield.


d.

Separate the harness from the front seat cushion shield, disconnect the connector, and remove the front seat cushion shield.


Hide 71811D 8.REMOVE FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)

a.
B200257

Remove the 2 hog rings and rubber bands of the seatback cover from the seat frame.


b.
B165809E01
0.842,0.612 0.942,0.764 0.100,0.152 10 1 1.276,1.165 1.376,1.317 0.100,0.152 10 2 1.858,1.295 1.958,1.447 0.100,0.152 10 2

Remove the 2 screws.


c.

Disengage the 3 claws in the order shown in the illustration, and then remove the front seat cushion shield.


Hide 84922A 9.REMOVE FRONT POWER SEAT LUMBAR SWITCH (for Driver Side)

Hide 71862 10.REMOVE FRONT SEAT CUSHION SHIELD INNER LH

a.
B190975E01
1.089,0.125 1.193,0.286 0.104,0.161 10 1 2.28,1.285 2.385,1.446 0.104,0.161 10 2 1.656,1.147 1.760,1.309 0.104,0.161 10 2

Remove the screw.


b.

Disengage the 3 claws in the order shown in the illustration, and then separate the front seat cushion shield.


c.

Separate the harness form the front seat cushion shield and remove the front seat cushion shield.


Hide 73240 12.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH

Hide 13.REMOVE SEAT CUSHION COVER WITH PAD (for Driver Side)

a.
B190976

Using a clip remover, remove the 2 clips.


b.
B190977

Disengage the 8 wire harness clamps.


c.
B194818

Remove the 2 hog rings.


d.
B195207

Disengage the wire harness clamp.


e.
B190980

Bend the 2 seat frame claws upward.


f.

Disengage the hooks and remove the seat cushion cover with pad.


Hide 14.REMOVE SEAT CUSHION COVER WITH PAD (for Front Passenger Side)

a.
B190978

Using a clip remover, remove the 2 clips.


b.
B190979

Disengage the 3 wire harness clamps.


c.
B194819

Remove the 2 hog rings.


d.
B190981

Bend the 2 seat frame claws upward.


e.

Disengage the hooks and remove the seat cushion cover with pad.


Hide 71072S 15.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

a.
B191005

Remove the 10 hog rings and seat cushion cover.


Hide 71931A 16.REMOVE FRONT SEAT HEADREST SUPPORT

a.
B190982

Remove the 3 hog rings.


b.
B190983

Disengage the hooks.


c.
B190984

Remove the 2 hog rings and seatback cover wires.


d.
B191055

Disengage the 4 claws and remove the 2 front seat headrest supports.


Hide 17.REMOVE SEATBACK COVER WITH PAD

a.
B190986

Lift the seatback cover and remove the nut and seatback cover bracket from the seat frame.


b.

Lift the seatback cover and remove the 4 hog rings and seatback cover with pad.


Hide 71074S 18.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

a.
B190987

Remove the 2 hog rings and seatback cover wires.


b.
B165535

Disconnect the seatback cover bracket from the seatback pad.


c.
B190988

Remove the 2 hog rings and seatback cover from the seatback pad.


Hide 71875B 19.REMOVE RECLINING ADJUSTER INSIDE COVER LH

a.
B191058

Remove the screw and reclining adjuster inside cover.


Hide 71875A 20.REMOVE RECLINING ADJUSTER INSIDE COVER RH

HINT:

Use the same procedure for the LH side and RH side.


Hide 71814A 21.REMOVE FRONT SEATBACK SHIELD LH

a.
B200256

Remove the screw.


b.

Disengage the claw and remove the front seatback shield.


Hide 71813A 22.REMOVE FRONT SEATBACK SHIELD RH (for Driver Side)

a.
B190991

Disengage the wire harness clamp.


b.

Remove the screw.


c.

Disengage the claw and remove the front seatback shield.


Hide 71873A 23.REMOVE FRONT SEAT CUSHION SHIELD LOWER LH

a.
B201576E01
1.359,2.927 1.867,2.532 false 1.359,2.927 1.867,2.532 false 1.359,2.927 1.867,2.532 false 0.118,2.828 1.124,3.014 1.005,0.186 10 Protective Tape 1.359,2.927 1.949,2.469 false

Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the front seat cushion shield lower.


Hide 71874C 24.REMOVE FRONT SEAT CUSHION SHIELD LOWER RH

HINT:

Use the same procedure for the LH side and RH side.


Hide 72760D 25.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (for Driver Side)

Hide 82192 26.REMOVE FRONT SEAT WIRE LH (for Driver Side)

Hide 82191 27.REMOVE FRONT SEAT WIRE RH (for Front Passenger Side)

a.
B190992

Disconnect the 4 connectors.


b.

Disengage the wire harness clamp and remove the front seat wire.