Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235859 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 89170 1.INSTALL AIRBAG SENSOR ASSEMBLY

B192369

a.

Confirm that the ignition switch is turned off.


b.

Confirm that the negative battery terminal is disconnected.

CAUTION:
·

Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.




c.

Install the airbag sensor with the 3 bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:
·

Do not use an airbag sensor that has been dropped.

·

Do not subject the airbag sensor to any impact or force.

·

Confirm that the carpet does not interfere with the installation plane.




d.

Confirm that there is no looseness by shaking the front airbag sensor.


e.
B192368E01
1.62,1.089 1.988,1.248 0.368,0.159 10 Lever 2.365,0.974 2.078,1.17 false

Connect the connector holder to lock the lever.

NOTICE:

Confirm that the lever is locked.



f.

Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.


Hide 58805C 6.INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 58804A 7.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 33504F 8.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 55046A 9.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

Hide 53601 10.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 62312B 12.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 67914B 15.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 17.INSPECT SRS WARNING LIGHT