Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the LH side and RH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY LH
Remove the front seat (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).
84921B
2.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH
84921A
3.REMOVE RECLINING POWER SEAT SWITCH KNOB
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD LH
73240
5.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
71862
6.REMOVE FRONT SEAT CUSHION SHIELD INNER LH
71931A
7.REMOVE FRONT SEAT HEADREST SUPPORT
8.REMOVE SEATBACK COVER WITH PAD
72760D
9.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/ Climate Control Seat System)
Disconnect the connector and detach the 2 wire harness clamps.
Remove the 4 springs.
Detach the 4 hooks and remove the seatback spring.
Disconnect the connector.
Remove the 2 screws and lumbar support adjuster assembly.
Detach the 3 claws and remove the bush from the seat frame.
72760D
10.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (w/o Climate Control Seat System)
Remove the 2 springs.
Detach the 6 hooks and remove the seatback spring.
Disconnect the connector.
Remove the 2 screws and lumbar support adjuster assembly.
Detach the 3 claws and remove the bush from the seat frame.