1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).
4.REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL).
71862
5.REMOVE FRONT SEAT CUSHION SHIELD INNER LH (for Manual Seat)
73240
6.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Manual Seat)
Disconnect the connector and disengage the 5 clamps.
Remove the nut and front seat inner belt LH.
Remove the front seat belt anchor plate.
73240
7.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Power Seat)
Disconnect the connector and disengage the 5 clamps.
Remove the nut and front seat inner belt LH.
Remove the front seat belt anchor plate.
73240
8.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (w/ Climate Control Seat System)
Disconnect the connector and disengage the 6 clamps.
Remove the nut and front seat inner belt LH.
Remove the front seat belt anchor plate.
73230
9.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Manual Seat)
Disengage the 3 clamps.
Remove the nut and front seat inner belt RH.
Remove the front seat belt anchor plate.
73230
10.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Power Seat)
Disconnect the connector and disengage the clamp.
Remove the nut and front seat inner belt RH.
Remove the front seat belt anchor plate.
73230
11.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (w/ Climate Control Seat System)
Disconnect the connector and disengage the clamp.
Remove the nut and front seat inner belt RH.
Remove the front seat belt anchor plate.