Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM27L0U _58 Vehicle Interior _049343 SEAT BELT _0235889 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 73200A 1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

a.
B194071

Align the front shoulder belt anchor adjuster positioning claw with the hole, and install the front shoulder belt anchor adjuster with the 2 bolts.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 73220 2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY

a.
B194070E02
2.25,0.313 2.365,0.677 0.115,0.365 10 true A 1.208,1.604 1.354,1.771 0.146,0.167 10 true B

Align the claws on the body with the front seat outer belt retractor positioning holes.


b.

Install the front seat outer belt with the 2 bolts.

HINT:

First install bolt A, and then install bolt B.


·

for Bolt A


Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

·

for Bolt B


Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


c.
B194069E02
0.781,3.646 0.781,3.906 true 0.365,3.896 1.313,4.073 0.948,0.177 10 false Locking Button

Connect the pretensioner connector as shown in the illustration.


d.
B194067

Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 62413A 4.INSTALL LOWER CENTER PILLAR GARNISH RH

Hide 62331C 5.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH

Hide 51775 7.INSTALL REAR FLOOR STEP NO. 1 COVER

Hide 62311B 8.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 10.INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)

a.

Hide 11.INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)

a.

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).