Use the same procedure for the LH side and RH side.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL).
4.REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
Remove the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL ).
67913
5.REMOVE FRONT DOOR SCUFF PLATE RH
62311B
6.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
58371F
7.REMOVE REAR FLOOR STEP NO. 1 COVER
67917A
8.REMOVE REAR DOOR SCUFF PLATE RH
62331C
9.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
62413A
10.REMOVE LOWER CENTER PILLAR GARNISH RH
62411
11.REMOVE CENTER PILLAR GARNISH RH
73220
12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut and shoulder anchor.
Disconnect the pretensioner connector as shown in the illustration.
Remove the 2 bolts and front seat outer belt.
73200A
13.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts and front seat shoulder belt anchor adjuster assembly.