Use the same procedure for the LH side and RH side.
The procedure listed below is for the RH side.
73200A
1.INSTALL REAR NO. 1 SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Align the rear No. 1 shoulder belt anchor adjuster positioning claw with the hole, and install the rear No. 1 shoulder belt anchor adjuster with the 2 bolts.
73360C
2.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
Align the claws on the body with the rear No. 1 seat outer belt retractor positioning holes.
Install the rear No. 1 seat outer belt with the 2 bolts.
First install bolt A, and then install bolt B.
for Bolt A
for Bolt B
Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.
87217E
3.INSTALL REAR SIDE NO. 2 AIR DUCT
62550F
4.INSTALL REAR WINDOW SIDE GARNISH ASSEMBLY RH
62510P
5.INSTALL QUARTER TRIM PANEL ASSEMBLY RH (for Manual Seat)
62510P
6.INSTALL QUARTER TRIM PANEL ASSEMBLY RH (for Power Seat)
58573A
7.INSTALL REAR FLOOR MAT SUPPORT PLATE
66310D
8.INSTALL ROPE HOOK ASSEMBLY
62331C
9.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
67917A
10.INSTALL REAR DOOR SCUFF PLATE RH
58371F
11.INSTALL REAR FLOOR STEP NO. 1 COVER
58372E
12.INSTALL REAR FLOOR STEP NO. 2 COVER
71693
13.INSTALL REAR SEAT CUSHION HINGE LOWER COVER RH
14.INSTALL REAR NO. 2 SEAT ASSEMBLY RH (for Manual Seat)
Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Manual Seat Type RH Side)>INSTALLATION).
15.INSTALL REAR NO. 2 SEAT ASSEMBLY RH (for Power Seat)
Install the rear No. 2 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Power Seat Type RH Side)>INSTALLATION).