Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER(w/ Air Cooled Transmission Oil Cooler)
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235923 CONDENSER(w/ Air Cooled Transmission Oil Cooler) A

HEATING / AIR CONDITIONING  CONDENSER(w/ Air Cooled Transmission Oil Cooler)  INSTALLATION  


PROCEDURE

Hide 88474 1.INSTALL COOLER DRYER

a.
E050386

Using pliers, install the cooler dryer.


b.
E344967

Apply a sufficient amount of compressor oil to the contact surfaces of a new O-ring and the cap.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the cap.


d.
I030086

Using a 14 mm socket hexagon wrench, install the cap to the modulator.

Torque:
2.9 N*m (30 kgf*cm, 26 in.*lbf)


Hide 88460 2.INSTALL COOLER CONDENSER ASSEMBLY

a.
E207130

Install the cooler condenser with the 2 bolts, as shown in the illustration.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


Hide 88710 3.CONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

E186078

a.

Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on the air conditioning tube and accessory.


d.

Connect the air conditioning tube and accessory on the cooler condenser with the 2 bolts.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)

NOTICE:
·

When tightening the bolt, do not allow any tools to contact the pipe.

·

When tightening the bolt, hold a part of the pipe near the connector.




Hide 88711 4.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

E207128

a.

Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on the discharge hose.


d.

Connect the discharge hose on the cooler condenser with the bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)

NOTICE:
·

When tightening the bolt, do not allow any tools to contact the pipe.

·

When tightening the bolt, hold a part of the pipe near the connector.




Hide 16400 5.INSTALL RADIATOR ASSEMBLY

a.

for 3UR-FE:

Install the radiator (see page Engine / Hybrid System>3UR-FE COOLING>RADIATOR>INSTALLATION).


b.

for 3UR-FBE:

Install the radiator (see page Engine / Hybrid System>3UR-FBE COOLING>RADIATOR>INSTALLATION).


Hide 32907A 6.CONNECT OIL COOLER HOSE

a.
E188044

Connect the 2 oil cooler hoses and attach the 2 clips.


Hide 52119A 7.INSTALL FRONT BUMPER COVER

a.

Install the front bumper cover (see page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION).