Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235939 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch  


DESCRIPTION

If the AUTO UP/DOWN function does not operate, the cause may be one or more of the following:

·

The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.

·

The power window regulator switch has a malfunction.

·

The Hall-IC in the power window regulator motor has a malfunction.

·

The wiring between the power window regulator switch and the power window regulator motor is open or short.


WIRING DIAGRAM

B184409E06
2.385,0.776 3.733,0.956 1.349,0.180 10 from Main Body ECU 5.491,2.666 6.041,2.836 0.549,0.170 10 DOWN 3.667,2.666 4.129,2.836 0.461,0.170 10 DOWN 4.255,2.583 4.449,2.739 0.194,0.156 10 7 5.225,3.056 5.357,3.208 0.132,0.152 10 4 5.225,2.579 5.357,2.732 0.132,0.152 10 7 5.491,3.139 5.897,3.308 0.406,0.170 10 AUTO 5.491,2.225 5.772,2.395 0.281,0.170 10 UP 5.491,1.101 5.648,1.271 0.156,0.170 10 B 5.491,1.514 5.869,1.684 0.378,0.170 10 GND 0.67,4.264 2.639,4.434 1.969,0.170 10 : LIN Communication Line 3.187,3.272 3.530,3.442 0.343,0.170 10 GND 3.715,3.139 4.135,3.309 0.420,0.170 10 AUTO 3.921,2.225 4.143,2.395 0.222,0.170 10 UP 4.255,2.134 4.463,2.287 0.208,0.152 10 6 5.265,1.007 5.386,1.159 0.121,0.152 10 2 5.265,1.404 5.386,1.556 0.121,0.152 10 1 5.186,2.119 5.394,2.271 0.208,0.152 10 10 2.594,3.684 4.631,4.051 2.037,0.368 10 Front Power Window Regulator Switch Assembly RH 4.965,3.836 6.917,4.178 1.952,0.342 10 Front Power Window Regulator Motor Assembly RH 2.957,3.195 3.066,3.351 0.109,0.156 10 1 2.657,3.512 2.887,3.668 0.230,0.156 10 L2 4.965,3.656 5.222,3.812 0.257,0.156 10 L3 4.255,3.056 4.450,3.212 0.194,0.156 10 8 0.871,1.082 1.657,1.397 0.787,0.316 10 from Battery 1.778,1.247 2.780,1.406 1.002,0.158 10 POWER NO. 4 5.255,0.643 5.365,0.810 0.110,0.168 10 9 5.491,0.79 5.749,0.938 0.257,0.147 10 LIN

PROCEDURE

1.CHECK DTC
a.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
B2311 is output B
B2312 is output C
B2313 is output D
LIN communication system DTCs are output E



A

2.CHECK MANUAL UP / DOWN FUNCTION

B

C

D

E

2.CHECK MANUAL UP / DOWN FUNCTION
a.

Check that the manual UP/DOWN function using the power window regulator switch can operate the front passenger side door power window (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Manual UP/DOWN function operates.




OK

3.READ VALUE USING TECHSTREAM (FRONT POWER WINDOW REGULATOR MOTOR RH)

NG

3.READ VALUE USING TECHSTREAM (FRONT POWER WINDOW REGULATOR MOTOR RH)
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / P-Door Motor / Data List.


e.

According to the display on the Techstream, read the Data List.

P-Door Motor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
P Door P/W Auto SW Front passenger side power window auto UP/DOWN switch signal / ON or OFF ON: Front passenger side power window auto UP/DOWN switch operated
OFF: Front passenger side power window switch not operated
-


OK:

The Techstream display changes when front passenger side power window switch is operated.



OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

NG

4.CHECK HARNESS AND CONNECTOR (FRONT POWER WINDOW SWITCH RH - FRONT POWER WINDOW MOTOR RH)
4.CHECK HARNESS AND CONNECTOR (FRONT POWER WINDOW SWITCH RH - FRONT POWER WINDOW MOTOR RH)
a.
U153216E01
0.161,1.978 2.675,2.702 2.514,0.723 10 Front view of wire harness connector: (to Front Power Window Regulator Motor Assembly RH) 0.161,0 2.645,0.704 2.484,0.704 10 Front view of wire harness connector: (to Front Power Window Regulator Switch Assembly RH) 0.636,1.07 0.865,1.255 0.229,0.184 10 L2 0.67,3.234 0.904,3.418 0.234,0.184 10 L3 2.402,1.529 2.822,1.691 0.420,0.162 10 AUTO 1.957,1.785 2.376,1.61 false 0.655,4.031 1.075,4.192 0.420,0.162 10 AUTO 1.177,4.102 1.612,3.877 false

Disconnect the L2 front power window regulator switch assembly RH connector.


b.

Disconnect the L3 front power window regulator motor assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L2-8 (AUTO) - L3-4 (AUTO) Always Below 1 Ω
L2-8 (AUTO) - Body ground Always 10 kΩ or higher



d.

Reconnect the front power window regulator motor assembly RH connector.


e.

Reconnect the front power window regulator switch assembly RH connector



OK

5.INSPECT FRONT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.INSPECT FRONT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
a.
U153217E02
0.875,2.563 1.427,2.083 true 2.073,1.885 2.333,2.656 true 0.042,0 2.802,0.365 2.76,0.365 10 false Component without harness connected: (Front Power Window Regulator Switch RH) 0.573,1.708 0.771,1.865 0.198,0.156 10 false L2 2.25,2.656 2.625,2.854 0.375,0.198 10 false GND 0.604,2.646 1.094,2.844 0.49,0.198 10 false AUTO

Remove the L2 front power window regulator switch assembly RH (See page Vehicle Exterior>WINDOW / GLASS>FRONT PASSENGER SIDE POWER WINDOW SWITCH>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
8 (AUTO) - 1 (GND) AUTO UP/DOWN operation Below 1 Ω



c.

Reinstall the front power window regulator switch assembly RH.



OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

NG

REPLACE FRONT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH