Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235945 POWER WINDOW REGULATOR MOTOR A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR  INSTALLATION  


PROCEDURE

Hide 85720D 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.
B191728

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.

Using "TORX" socket wrench T25, install the power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 69803 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

Hide 68103 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67406B 4.INSTALL REAR DOOR WINDOW FRONT GUIDE SUB-ASSEMBLY

Hide 67408F 5.INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY

Hide 68152C 6.INSTALL REAR DOOR GLASS RUN

Hide 68163H 7.INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR DOOR BELT MOULDING>INSTALLATION).


Hide 75765A 8.INSTALL REAR DOOR WINDOW FRAME REAR MOULDING

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR DOOR WINDOW FRAME MOULDING>INSTALLATION).


Hide 67841E 9.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67626C 10.INSTALL REAR DOOR TRIM NO. 2 BRACKET

Hide 67603 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 69283A 12.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 74271A 13.INSTALL REAR DOOR ARMREST BASE UPPER PANEL

Hide 67673A 14.INSTALL REAR DOOR FRAME GARNISH

Hide 85710D 15.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.
B191727

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.

Using "TORX" socket wrench T25, install the front power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 69801 16.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

Hide 68101 17.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 68141E 18.INSTALL FRONT DOOR GLASS RUN

Hide 67831 19.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67625A 20.INSTALL NO. 1 FRONT DOOR TRIM BRACKET

Hide 68160C 21.INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT DOOR BELT MOULDING>INSTALLATION).


Hide 87910 22.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>INSTALLATION).


Hide 67602 23.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74231 24.INSTALL FRONT ARMREST BASE UPPER PANEL

Hide 69277B 25.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 67491A 26.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 27.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)