Use the same procedure for the RH side and LH side.
The procedure described below is for the LH side.
75766A
1.REMOVE REAR DOOR WINDOW FRAME REAR MOULDING
68164A
2.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP
67674A
3.REMOVE REAR DOOR FRAME GARNISH
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY).
69284D
4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY).
74272A
5.REMOVE REAR DOOR ARMREST BASE UPPER PANEL
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY).
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY).
68152C
7.REMOVE REAR DOOR GLASS RUN
Use the same procedure as for the RH side (See page Vehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY).
75924C
8.REMOVE NO. 2 BLACK OUT TAPE
Using an infrared light, heat the No. 2 black out tape.
Do not burn yourself on the hot rear door panel or with the infrared light.
Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.
Lift the end portion with your nail and peel it parallel to the attachment surface.