Home › BRAKE › PARKING BRAKE › PARKING BRAKE PEDAL

PARKING BRAKE PEDAL > INSTALLATION

for Preparation Click here



1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY


    F045025
  1. Install the parking brake control pedal assembly with a bolt and the 2 nuts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

  1. Connect the parking brake switch connector.

  1. Connect the instrument panel junction block assembly w/ wiring harness connector with the 4 nuts.

    Torque:
    7.3 N*m{ 74 kgf*cm , 65 in.*lbf }



2. INSTALL REAR FLOOR SEAT LOCK COVER


3. INSTALL REAR FLOOR SEAT LOCK COVER


4. INSTALL REAR SEAT NO.1 ASSEMBLY

HINT:
  1. Captain Seat Type (Click here)
  2. Center Seat Type (Click here)



5. INSTALL FRONT SEAT ASSEMBLY LH

HINT:
  1. Manual Seat Type (Click here)
  2. Power Seat Type (Click here)
  3. Fold Flat Type (Click here)



6. INSPECT PARKING BRAKE PEDAL TRAVEL
  1. Slowly depress the parking brake pedal all the way, and count the number of clicks.

    Parking brake pedal travel:
    3 to 5 clicks at 294 N (30 kgf, 66.0 lbf)



7. ADJUST PARKING BRAKE PEDAL TRAVEL
  1. Depress the parking brake pedal 3 notches to make a room for the procedure, and loosen the lock nut.

  1. Return the parking brake pedal to the original position.

  1. Turn the adjusting nut until the parking brake pedal travel corrects.



    F045024E01
  1. Depress the parking brake pedal 3 notches to make a room for the procedure, and tighten the lock nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Return the parking brake pedal to the original position.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake pedal, check that the parking brake pedal indicator light goes on.