Home › Brake › BRAKE (FRONT) › FRONT BRAKE (except 4-Pot Caliper)
RM3650E _54 Brake _079879 BRAKE (FRONT) _0387541 FRONT BRAKE(except 4-Pot Caliper) A

BRAKE (FRONT)  FRONT BRAKE(except 4-Pot Caliper)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT DISC

a.

Position front disc on front axle hub sub-assembly.


b.

Replace 5 mm hexagon bolt.


c.

Tighten the 5 mm hexagon bolt.

Torque:
16 N*m (163 kgf*cm, 12 ft.*lbf)


d.
C413460

Position the front disc brake cylinder mounting (2).


e.

Replace E16 bolts (1).


f.

Tighten the E16 bolts (1).

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


Hide 2.INSTALL FRONT DISC BRAKE PAD

a.
C413321

Clean the contact surface (1) of the front disc brake piston with brake cleaner and apply a thin coat of brake pad paste.


b.

Check the cylinder boot for damage and replace if necessary.


c.
C413322

Clean the contact surface of the front disc brake cylinder assembly with brake cleaner and apply a thin coat of brake pad paste.


d.
C413320

Clean the contact surface (1) of the front disc brake cylinder mounting with brake cleaner and apply a thin coat of brake pad paste.

NOTICE:

Do not mechanically clean the contact surfaces (1) for the front disc brake pads at the front disc brake cylinder mounting to prevent damage to the surface coating.



e.
C413324

Lightly coat the T-head of the outer front disc brake pad with brake pad paste in this area.


f.
C413323

Coat the T-head of outer front disc brake pad in the marked area (1) in each case with a thin coating of brake pad paste.


g.
C413325

Install the front disc brake pads (1) in the direction of the arrow.


Hide 3.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY

a.
C409011

Install the front disc brake cylinder assembly (3).


b.

Replace bolts (1).


c.

Tighten the bolts (1).

Torque:
35 N*m (357 kgf*cm, 26 ft.*lbf)

HINT:

If applicable, hold against the hexagon head (2).



d.

Position front flexible hose on the front disc brake cylinder assembly.

NOTICE:

Make sure that the front flexible hose does not rest against the components fixed to the body and that it is not twisted.



e.
C420441C01
1.583,3.094 1.896,3.25 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Tighten front flexible hose (1) on the front disc brake cylinder assembly, if necessary counter at the knurling (2).

SST
09700-WA070  

Torque:
Specified tightening torque : 17 N*m (173 kgf*cm, 13 ft.*lbf)

HINT:

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



f.

If required, attach front flexible hose to the bracket (3).


Hide 6.INSTALL FRONT WHEEL