Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL FRONT FLEXIBLE HOSE
Position front flexible hose on the front disc brake cylinder assembly.
| *a | Torque Wrench Fulcrum Length |
Tighten 11 mm union nut (1), if necessary counter at the knurling (2).
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Attach cable to the bracket (3).
| *a | Torque Wrench Fulcrum Length |
Tighten 11 mm union nut (1) on the brake tube, if necessary counter on the hexagon head (2).
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
53879
2.INSTALL FRONT FENDER LINER
3.REMOVE BRAKE PEDAL PRESSURE
4.BLEED BRAKE LINE
5.INSTALL FRONT WHEEL