Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH
RM3650E _58 Vehicle Interior _079892 THEFT DETERRENT / KEYLESS ENTRY _0387778 ENGINE HOOD COURTESY SWITCH A

THEFT DETERRENT / KEYLESS ENTRY  ENGINE HOOD COURTESY SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


CAUTION:
·
B422343

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 53826A 2.REMOVE UPPER FRONT FENDER PROTECTOR LH

Hide 53510 3.REMOVE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)

a.
E415801

Detach the No. 5 water by-pass hose (1) from the radiator reserve tank assembly (2).

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.





b.

w/ Pop Up Hood:

CAUTION:
·
B475753

Pyrotechnic components.

Danger! Life-threatening injuries!

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.




i.
E415802

Detach the clamps (1).


ii.

Disconnect the connectors (2).



c.
E416621

w/o Pop Up Hood:

i.

Detach the clamps (1).


ii.

Disconnect the connector (2).



d.
E415803

Detach the clamp (1).


e.

Loosen the T30 screws (2).


f.
E415804C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the engine hood courtesy switch (hood lock assembly) (1) in the upward direction.


g.

Detach the cable (2) from the engine hood courtesy switch (hood lock assembly) (1).