Airbag unit.
Danger! Life-threatening injuries!
Before performing any work on the airbag, always disconnect the battery earth lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
For additional information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Child restraint seat anchor bracket is installed to the front passenger side.
71811D
1.REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER (for Manual Seat)>REMOVAL
2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL
71861
3.REMOVE FRONT SEAT CUSHION INNER SHIELD (for Power Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY
71811D
4.REMOVE FRONT SEAT CUSHION SHIELD (for Power Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
73706A
5.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET
Drill out the rivets (1).
Do not drill the rivet at an angle as this will cause damage to the drill and rivet installation hole. Line up the drill with the rivet, and carefully drill out the rivet head.
Be careful as the drilled rivet will be very hot.
Use the same procedure for the opposite side.