Airbag unit.
Danger! Life-threatening injuries!
Before performing any work on the airbag, always disconnect the battery earth lead from the battery.
|
Cushion (Airbag Itself) |
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
For additional information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
Steering wheel must be replaced if airbag unit has been deployed.
For more information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>INSPECTION AFTER COLLISION>INSPECTION
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for B48:
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
for B58:
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
45130
2.REMOVE HORN BUTTON ASSEMBLY
Airbag unit.
Danger! Life-threatening injuries!
Before performing any work on the airbag, always disconnect the battery earth lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
For additional information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Steering wheel must be replaced if airbag unit has been deployed.
For more information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>INSPECTION AFTER COLLISION>INSPECTION
Check that the START-STOP button (engine switch) off.
Pressing and holding the AUDIO button changes the power source mode to IG OFF.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Insert the "TORX" screwdriver T25 diagonally upwards into concealed opening on the rear side (1) of steering wheel assembly (2) until a springy resistance can be felt.
Use the same procedure as for the opposite side.
Spreading your hands to hold it over a large area, push the entire horn button assembly (1) against the steering wheel assembly (2) so that the wire spring clips (3) are raised up from the hooks (4).
|
Push |
|
Raised up |
While pushing and holding the entire horn button assembly, use the "TORX" screwdriver T25H to push the wire spring clips (1) towards the center of the steering wheel assembly and disengage the wire spring clips (1).
|
Push |
|
Remove in this Direction |
Unlock the plug connection (1) and disconnect.
Remove the horn button assembly.