Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387807 FRONT SEAT SIDE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753


·

Airbag unit.

Danger! Life-threatening injuries!

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-
B399378C09
0,0 0,0 false
V100155

Cushion (Airbag Itself)


Airbag unit may only be set down with the cushion (airbag itself) facing upwards.

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.



·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY

Hide 71862 2.REMOVE FRONT SEAT CUSHION INNER SHIELD

Hide 71822 3.REMOVE FRONT SEAT SIDE SHIELD (for Manual Seat)

Hide 4.REMOVE RECLINING CONTROL LINK SUB-ASSEMBLY (for Manual Seat)

Hide 72495 5.REMOVE VERTICAL ADJUSTING HANDLE (for Manual Seat)

Hide 71812D 6.REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat)

Hide 71812D 7.REMOVE FRONT SEAT CUSHION SHIELD (for Power Seat)

Hide 73920A 8.REMOVE FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
·

Airbag unit.

Danger! Life-threatening injuries!

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-

Airbag unit may only be set down with the cushion (airbag itself) facing upwards.




a.
B539399

Loosen the tie band (1).


b.

Detach the claws (4) carefully.


c.

Remove the connector (2) in the direction of the arrow from the connector housing (3).


d.
B538767

Remove the connector (1) from the connector housing (2).


e.
B538768

Detach the separate type front seat cushion cover (1).


f.

Detach the clamps (2).


g.
B538769

Detach the separate type front seatback cover (1) in the marked area.


h.
B538770

Using a special tool 0 490 472 (00 5 020), open the fasteners (1) in the marked area.

SST
09300-WA180  


i.
B538771

Detach the separate type front seatback cover (1) in the marked area.


j.
B538772

Loosen the nuts (1).


k.

Fold the separate type front seatback cover with pad (2) to the side.


l.
B538773

Carefully remove the front seat airbag assembly (1) from the separate type front seatback pad (2).


m.

Carefully remove the front seat airbag assembly (1) from the pocket in the separate type front seatback cover (3).

NOTICE:

Make sure that the stud bolts (4) do not damage the pocket in the cover.