Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3650E _59 Vehicle Exterior _079908 LIGHTING (EXT) _0387829 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Rear Side)

a.
E414394

Replace the bolts (1).


b.

Install the rear height control sensor sub-assembly (2) with the T20 screws (1).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


c.
E414393

Engage the clamp (1).


d.

Connect the connector.


Hide 48738 2.INSTALL REAR SUSPENSION ARM COVER LH (for Rear Side)

Hide 3.INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for Front Side)

a.
E414399

Replace the bolts (1).


b.

Install the front height control sensor sub-assembly (2) with T20 screws (1).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


c.
E414398

Engage the clamp (1).


d.
E414397

Connect the connector (1).


e.

Engage the clamp (2).


Hide 4.INSTALL FRONT WHEEL LH (for Front Side)

Hide 5.ADJUST HEIGHT CONTROL SENSOR

a.

Connect the diagnosis system to the vehicle and enter the following menus:

Vehicle management / Service functions / Chassis / Vertical dynamics platform / Ride height adjustment / ABL Ride height sensors: Start-up