Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach the cable from the negative (-) battery terminal.
Airbag unit.
Danger! Life-threatening injuries!
All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
Before performing any work on the airbag, always disconnect the battery earth lead from the battery.
For additional information see:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for B48:
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
for B58:
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
75720
2.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY
68102
3.LOOSEN FRONT DOOR GLASS SUB-ASSEMBLY
81230
4.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
67602
5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
6.REMOVE SIDE AIRBAG PRESSURE SENSOR
7.REMOVE SOUND INSULATION
68172A
8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
68102
9.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
69820
10.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY
69220
11.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY
69760B
12.REMOVE FRONT DOOR INSIDE LOCKING CABLE (FOR LOCK / UNLOCK KNOB)
Unlock the lock mechanism (1) and remove the front door inside locking cable (for lock / unlock knob) (2) towards the rear from front door lock with motor assembly (3).
The front door inside locking cable (for lock / unlock knob) (2) slides out on its own.
69040A
13.REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY
Using a 4 mm hexagon wrench, loosen screw (1).
Remove the front door outside handle cover (2).
Loosen T20 screw (1).
Unclip front door lock open rod (1).
Unlock and disconnect the connector on the front door lock with motor assembly (3) at inner.
Release the wiring harness from the front door lock with motor assembly (3) on the inner.
Loosen T30 bolts (2) and (4).
Guide out the front door lock with motor assembly (3) together with the front door outside handle frame sub-assembly and remove.
69202A
14.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
Disconnect the front door lock control link sub-assembly (1) from the front door lock with motor assembly (2).
Disconnect the front door lock remote control cable (for open lever) (1).
Disconnect the front door lock remote control cable (for open lever) nipple (2).
Lift the lug (1) over the clip and twist it upwards.
Disconnect the front door lock remote control cable (for open lever) (2).
Disconnect the front door lock remote control cable (for open lever) nipple (3).