Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › ENGINE WIRE HARNESS
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388339 ENGINE WIRE HARNESS A

B58 ENGINE CONTROL  ENGINE WIRE HARNESS  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53681 2.REMOVE UPPER FRONT SUSPENSION CENTER BRACE

Hide 55788A 3.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 82124 6.REMOVE NO. 4 ENGINE WIRE

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




HINT:
·

Follow instructions for removing and installing control units.

·

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Disconnecting control units may cause fault code entries and functional limitations. Fault code entries must be read out and deleted if necessary.



a.
A442111

Release snap-lock couplings (1).


b.

Feed the cover (2) out toward the top and remove.


c.
A442112

Unlock and disconnect all plug connections (1).


d.
A442178

Disconnect connector (1) from ECM.


e.

Release No. 4 engine wire from bracket (2).


f.

Release No. 4 engine wire from the clamp (3).


g.

Release No. 4 engine wire from the clamp (4).


h.
A442179

Unlock and disconnect all connectors (1) of the ignition coils.


i.

Release nuts (2) and remove ground cable.


j.

Unlock and pull off all connectors (3) of the injectors.


k.
A441736

Push the lock (1) upward in the direction of the arrow.


l.

Press lock (1) together and release.


m.

Pull off the connector (2) from the injectors.