Home › Engine / Hybrid System › B58 (LUBRICATION) › OIL LEVEL SENSOR
RM3650E _51 Engine / Hybrid System _080066 B58 LUBRICATION _0388390 OIL LEVEL SENSOR A

B58 LUBRICATION  OIL LEVEL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 12180E 3.REMOVE OIL FILLER CAP ASSEMBLY

Hide 15620 4.REMOVE OIL FILTER CAP ASSEMBLY

Hide 12101A 5.REMOVE OIL PAN DRAIN PLUG

Hide 51219 6.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 12101A 7.INSTALL OIL PAN DRAIN PLUG

Hide 12140 8.REMOVE OIL PAN COVER

Hide 9.REMOVE ENGINE OIL LEVEL SENSOR

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.



·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.



NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A442193

Unlock plug connection (1) and disconnect.


b.

Loosen nuts (2).


c.

Remove the engine oil level sensor (3).