Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach battery earth lead from battery.
For an auxiliary battery: Disconnect battery earth lead of auxiliary battery.
Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.
Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.
1. DISCHARGE FUEL SYSTEM PRESSURE
2.DISCONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
85010
3.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
53383
4.REMOVE HOOD TO COWL TOP SEAL
53681
5.REMOVE UPPER FRONT SUSPENSION CENTER BRACE
55788A
6.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR
11271A
7.REMOVE REAR CYLINDER BLOCK COVER
8.REMOVE IGNITION COIL ASSEMBLY
23802B
9.REMOVE NO.2 FUEL PIPE SUB-ASSEMBLY
Working on fuel system.
Risk of fire! Danger of explosion!
When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.
Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.
No fire, sparks, open flames or smoking.
On releasing high pressure line, fuel may emerge at high speed.
Danger of injury!
Wear suitable personal protective equipment.
Allow the cooling system to cool down to a temperature below 40°C before starting installation work.
Note warnings on cylinder head cover.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Unlock and loosen clamp (1)
Unlock and remove the snap fastener (2) in the direction of the arrow.
Catch and dispose of escaping fuel.
Loosen screw (3).
Release the union nut (1) with the 17 mm union nut wrench on the high pressure pump.
Catch and dispose of escaping fuel.
Guide the fuel feed line (3) out of the holder (2).