Home › Engine / Hybrid System › B48 (FUEL) › FUEL TUBE (for Front)
RM3650E _51 Engine / Hybrid System _080098 B48 FUEL _0388613 FUEL TUBE(for Front) A

B48 FUEL  FUEL TUBE(for Front)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on fuel system.

·

Risk of fire! Danger of explosion!

-

When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.

-

Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.

-

No fire, sparks, open flames or smoking.



·

Working on 12 V vehicle electrical system.

·

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.

-

For an auxiliary battery: Disconnect battery earth lead of auxiliary battery.



·

On releasing high pressure line, fuel may emerge at high speed.

·

Danger of injury!

-

Wear suitable personal protective equipment.

-

Allow the cooling system to cool down to a temperature below 40°C before starting installation work.

-

Note warnings on cylinder head cover.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).

·

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 2.DISCONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 12601B 3.REMOVE NO.1 ENGINE COVER SUB-ASSEMBLY

Hide 11272 4.REMOVE NO. 2 CYLINDER BLOCK SIDE COVER

Hide 23801P 6.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY

CAUTION:
·

Working on fuel system.

·

Risk of fire! Danger of explosion!

-

When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.

-

Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.

-

No fire, sparks, open flames or smoking.



·

On releasing high pressure line, fuel may emerge at high speed.

·

Danger of injury!

-

Wear suitable personal protective equipment.

-

Allow the cooling system to cool down to a temperature below 40°C before starting installation work.

-

Note warnings on cylinder head cover.




HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
A442217

Remove the cover (1).


b.
A441502

Unscrew the union nuts (1) with the 17 mm union nut wrench.


c.

Catch and dispose of escaping fuel.


d.

Feed the No. 1 fuel pipe sub-assembly (2) out and remove.