Home › Power Source / Network › B48 (BATTERY / CHARGING) › GENERATOR WIRE
RM3650E _57 Power Source / Network _080072 B48 BATTERY / CHARGING _0388701 GENERATOR WIRE A

B48 BATTERY / CHARGING  GENERATOR WIRE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Disconnect the cable from the negative (-) battery terminal.



·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53681 2.REMOVE UPPER FRONT SUSPENSION CENTER BRACE

Hide 55788A 3.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 11271A 8.REMOVE REAR CYLINDER BLOCK COVER

Hide 82261A 9.REMOVE GENERATOR WIRE

a.
A441478

Unlock the locks (1).


b.

Guide and remove terminal cover (2) in the direction of the arrow.


c.
A442133

Unfasten nut (1).


d.

Loosen clamp (2).


e.

Feed out generator wire (3) and put to one side.


f.
A442134

Feed the radiator reserve tank hose, No.2 radiator hose and water by-pass hose (1) with the holder out and set them aside.


g.
A442136

Unfasten nut (1).


h.

Thread out generator wire (2) and set it aside.


i.
A442171

Unclip generator wire in the marked areas.


j.
A441486

Release the clamps (arrows).


k.

Remove generator wire (1).