Hot fluids.
Risk of scalding!
Conduct all work in the vehicle wearing appropriate personal protective equipment only.
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51219
2.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR
3.DRAIN ENGINE COOLANT (for High Temperature)
4.DRAIN ENGINE COOLANT (for Low Temperature)
12180E
5.REMOVE OIL FILLER CAP ASSEMBLY
15620
6.REMOVE OIL FILTER CAP ASSEMBLY
12101A
7.REMOVE OIL PAN DRAIN PLUG
12101A
8.INSTALL OIL PAN DRAIN PLUG
17111
9.REMOVE INTAKE MANIFOLD
16267K
10.REMOVE NO. 3 WATER BY-PASS HOSE
Detach the retaining clip (1).
Remove the No. 3 water by-pass hose and set aside.
16282F
11.REMOVE NO. 5 WATER BY-PASS HOSE
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Unlock and disconnect the heater water hose (1).
Unlock and disconnect the No. 5 water by-pass hose (1).
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Remove the No. 5 water by-pass hose (1).
17138B
12.REMOVE INTAKE MANIFOLD STAY
Loosen E10 bolt (1).
Unscrew the bolt from the bottom.
Remove the intake manifold stay (2).
15671
13.REMOVE OIL FILTER BRACKET
Unscrew the nut (1) and remove the alternator wire (2).
Pull the cable clip (1) off the oil filter bracket (2).
Loosen E10 bolts in the order (5) to (1).
Remove oil filter bracket upwards.