Home › Engine / Hybrid System › B58 (ENGINE MECHANICAL) › ENGINE
RM3650E _51 Engine / Hybrid System _080179 B58 ENGINE MECHANICAL _0388883 ENGINE G

B58 ENGINE MECHANICAL  ENGINE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT COMPRESSION

a.

Remove No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>B58 (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL


b.
A442114

Remove No. 1 engine cover.

i.

Detach the service opening (2) in the marked areas (arrows) and twist it to the side at the pivot point (1).




d.

Remove spark plug.

Click hereGeneral>MAINTENANCE>B58 SPARK PLUG>REMOVAL


e.

Disconnect plug connection (1).

i.
A446756C01
0,0 0,0 false
V100135

Front of Engine


Unlock and disconnect plug connection (1) from the ECM.



f.

Check compression of all cylinders.

i.
A444844

Desired state

·

Compression pressures of the cylinders are above the minimum compression pressure. Compression pressure difference between two cylinders in comparison is below the limit.

Minimum Standard Compression Pressure:

900 kPa (9.2 kgf/cm2, 131 psi)


Maximum Pressure Difference between Each Cylinder:

250 kPa (2.5 kgf/cm2, 36 psi)




ii.

Compression pressures of the cylinders are below the minimum compression pressure.


iii.

Compression pressure difference between two cylinders in comparison is above the limit.


iv.

Remove compression gauge.



g.

Connect connector (1).

i.
A446756C02
0,0 0,0 false
V100135

Front of Engine


Connect connector A46*6B to the ECM and lock.


ii.

Make sure the connector engages audibly.



h.

Install spark plug.

Click hereGeneral>MAINTENANCE>B58 SPARK PLUG>INSTALLATION



j.

Install No. 1 engine cover.

i.
A442114

Turn the rear cylinder block cover (2) at the pivot point (1) to the installation position and guide it in where marked (arrows).



k.

Install No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>B58 (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION


Hide 2.INSPECT INTERNAL ENGINE PRESSURE


b.

Remove the oil filler cap assembly.

Click hereGeneral>MAINTENANCE>B58 OIL AND OIL FILTER>REPLACEMENT


c.

Checking the internal engine pressure.

i.
A455702

Insert special tool 2 471 014 into opening of oil filler neck and apply hand-tighten.

SST
09200-WA960  


ii.

Connect the connecting hose to the connection (1) on the special tool 2 471 014.

SST
09200-WA960  

Testing equipment:
Connecting hose
Diameter = 8 x 13 mm, length = 70 mm



iii.

Connect connecting hose using an appropriate pressure measuring device.


iv.

Start engine and run at idle speed.


v.

Connect diagnosis system.


vi.

Measuring the internal engine pressure.


vii.

Enter measured values manually in the diagnostic system.


viii.

Observe diagnosis instructions.



d.

Deviation between measured value and ambient pressure.


e.

Determine possible cause using table and rectify.

Deviation Possible cause Solution
Measured value < ambient pressure Pressure control valve faulty Replace the pressure control valve
Measured value > ambient pressure Engine ventilation blocked Clean the engine ventilation


f.

Install the oil filler cap assembly.

Click hereGeneral>MAINTENANCE>B58 OIL AND OIL FILTER>REPLACEMENT