Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM3650E _52 Drivetrain _080261 AXLE AND DIFFERENTIAL _0389247 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 43502C 1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY

a.
C413464

Make sure that the contact surfaces (1) on the steering knuckle and front axle hub sub-assembly are clean and free from oil and grease.


b.
C419696C01
1.125,0.615 1.708,0.604 true 1.75,0.531 2.063,0.688 0.313,0.156 10 true *a
*a Long "TORX" Socket Wrench


Position front axle hub sub-assembly.


c.

Replace T60 bolts (1).


d.

Tighten the T60 bolts (1).

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)


e.

Using SST, tighten the T60 bolts (1) an additional 90°.

SST
09900-WA010  

HINT:
C417459C02
2.99,1.271 3.156,1.188 false 2.906,2.094 2.906,1.76 false 0.875,3 1.208,3 false 0.104,0.125 0.417,0.281 0.313,0.156 10 false *a 0.448,0.125 0.76,0.281 0.313,0.156 10 false *b 2.042,0.125 2.354,0.281 0.313,0.156 10 false *c 3.188,1.073 3.427,1.271 0.24,0.198 10 false *d 2.854,2.146 3.167,2.302 0.313,0.156 10 false *b 1.302,2.927 1.615,3.083 0.313,0.156 10 false *c
*a Example
*b Before Tightening
*c After Tightening
*d Magnetic Portion


·

The magnetic portion is used to secure the gauge to the vehicle.

·

After first adjusting the needle of the gauge to 0°, tighten to the specified angle.

·

Perform the work procedure carefully so that the gauge, etc. does not become tilted.




Hide 48630 2.CONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY

Hide 3.INSTALL FRONT BRAKE DISC (for 4-Pot Caliper)

Hide 4.INSTALL FRONT BRAKE DISC (except 4-Pot Caliper)

Hide 5.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT