Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM3650E _52 Drivetrain _080261 AXLE AND DIFFERENTIAL _0389249 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.

Danger! Life-threatening injuries!

-

Observe safety information on raising the vehicle using a vehicle hoist.




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT BRAKE DISC (for 4-Pot Caliper)

Hide 2.REMOVE FRONT BRAKE DISC (except 4-Pot Caliper)

Hide 3.REMOVE FRONT DISC BRAKE DUST COVER

a.
C413604

Loosen bolts (1).


b.

Remove the front disc brake dust cover (2).


Hide 48630 4.DISCONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY

Hide 43502C 5.REMOVE FRONT AXLE HUB SUB-ASSEMBLY

Hide 6.DISCONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY

Hide 45047 7.DISCONNECT TIE ROD END SUB-ASSEMBLY

Hide 8.REMOVE BRAKE HOSE BRACKET

a.
C417463

Release the bolts (1) and remove the brake hose bracket (2) on the steering knuckle.


Hide 43212 9.REMOVE STEERING KNUCKLE

a.
C413458

Unfasten 16 mm nut (1).


b.

Remove holder (2).


c.
C413455

Spread the steering knuckle (1) with the special tool 0 494 541 (31 2 230).

SST
09600-WA030  

NOTICE:

Secure component against falling.



d.

Pull the steering knuckle (1) in the direction of arrow and remove from the front shock absorber assembly.