Home › Engine / Hybrid System › B58 (ENGINE MECHANICAL) › ENGINE WIRE HARNESS (for No. 2)
RM3650E _51 Engine / Hybrid System _080179 B58 ENGINE MECHANICAL _0388915 ENGINE WIRE HARNESS(for No. 2) A

B58 ENGINE MECHANICAL  ENGINE WIRE HARNESS(for No. 2)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.

-

For an auxiliary battery: Disconnect battery earth lead of auxiliary battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53681 2.REMOVE FRONT SUSPENSION BRACE UPPER CENTER

Hide 55788A 3.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17880 7.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 51219 8.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 82122 9.REMOVE NO. 2 ENGINE WIRE

Overview: No. 2 engine wire
A442186

NOTICE:
·

Damage to wires when disconnecting connectors and plug connections.

Sheared wires can cause a short circuit.

-

Do not pull on the wires when disconnecting connectors and plug connections.




a.
A442187

Unlock connector (1) and pull off.


b.

Disconnect connector (2) from the No. 1 integration relay.


c.

Disconnect connector (3) from ECM.


d.

Unlock and disconnect the connector (4) of the No. 1 check valve.


e.

Loosen clamps (5).


f.
A442188

Unlock and disconnect the connector (1) of the camshaft position sensor (for Exhaust Side).


g.

Unlock and disconnect the connector (2) of the fuel delivery pipe.


h.

Unlock and disconnect the connector (3) on the No. 1 fuel vapor feed hose.


i.

Unlock and disconnect the connector (4) of the servo motor.


j.
A442189

Unlock and disconnect the connector (1) of the fuel pump assembly (for High Pressure).


k.

Unlock and disconnect connector (2) of oxygen sensor.


l.

Unlock and disconnect the connector (3) of the wide range air fuel ratio sensor.


m.

Unlock and disconnect the connector (4) of the camshaft position sensor (for Intake Side).


n.

Unlock cable channel (5) and detach from cylinder head cover.


o.
A442190

Unlock and disconnect the connector (1) of the intake mass air flow meter sub-assembly.


p.

Unlock and disconnect the connector (2) of the turbocharger actuator and link assembly.


q.

Unlock and disconnect the connector (3) of the compressor inlet elbow.


r.
A442191

Unlock and disconnect the connector (1) of the vanos actuator (for Intake Side).


s.

Unlock and disconnect the connector (2) of the vanos actuator (for Exhaust Side).


t.
A442192

Unlock and disconnect the connector (1) of the water pump assembly (for Heater).