Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach battery earth lead from battery.
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
B48 BATTERY
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
B58 BATTERY
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
55606
2.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55607
3.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
4.REMOVE ETHERNET SWITCH
Electrostatic discharge.
Damage to or destruction of electrical components.
Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
Antistatic work clothing and antistatic shoes (with ESD symbol).
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
Do not pull on the wires when disconnecting connectors and plug connections
Unlock plug connections (1) and disconnect.
Detach the guides (2) to remove the ethernet switch (1).