Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS


    F052120E02
  1. If the skid control ECU detects a malfunction, the ABS and/or BRAKE warning lights come on in accordance with the trouble area to warn the driver.
    The table below indicates which lights come on when there is a malfunction in a particular function.

    Item/Trouble Area
    ABS System
    EBD System
    Skid Control ECU
    ABS Warning light
    ○
    ○
    ○
    BRAKE Warning light
    -
    ○
    ○
    ○: Light ON
    -: Light OFF

    HINT:
    1. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the intelligent tester.
    2. This system has a sensor signal check function (Click here). The DTCs can be read by connecting SST (09843-18043) between terminals TC and CG of the DLC3 and observing the blinking of the ABS warning light, or by connecting a intelligent tester (Click here).


WARNING LIGHT CHECK
  1. Release the parking brake.

    NOTICE:
    When releasing the parking brake, set chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.



  2. F052120E02
  3. Check that the ABS warning light and BRAKE warning light come on when the ignition switch is turned on and go off in about 3 seconds.

    HINT:
    If the warning lights do not illuminate, confirm whether the bulbs have burned out, and also check the wire harness between the skid control ECU and the combination meter.
    If the warning light remains on, troubleshoot the effected light circuit by proceeding to the page indicated below:
    Trouble Areas
    See Page
    ABS warning light circuit
    Click here
    BRAKE warning light circuit
    Click here