Home › ENGINE ยท 2TR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE REAR OIL SEAL


G037553E01
  1. Apply a light coat of MP grease to the lip of a new oil seal.

    NOTICE:
    Keep the lip free of foreign objects.

  1. Using SST and a hammer, tap the oil seal in until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-15030  
    09950-70010   (09951-07150)

    NOTICE:
    1. Do not tap the oil seal in at an angle.
    2. Wipe any extra grease off the crankshaft.



2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


G038107E01
  1. Clean the 10 bolts and 10 bolt holes.

  1. Apply adhesive to 2 or 3 threads of the 10 bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    G035062E04
  1. Using several steps, uniformly install and tighten the 10 bolts in the sequence shown in the illustration.

    Torque:
    27 N*m{ 270 kgf*cm , 20 ft.*lbf }



    G035063E01
  1. Mark the bolts with paint as shown in the illustration.

  1. Retighten the bolts by 90° in the same sequence as in step (d).

  1. Check that the paint mark of each bolt is at a 90° from the original position.

    NOTICE:
    Do not start the engine for at least 1 hour after installation.



3. INSTALL DRIVE PLATE and RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


G038107E01
  1. Clean the 10 bolts and 10 bolt holes.

  1. Apply adhesive to 2 or 3 threads of the 10 bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Provisionally install the drive plate spacer front, drive plate and ring gear and drive plate rear with the 10 bolts.

  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A099868E06
  1. Using several steps, uniformly install and tighten the 10 bolts in the sequence shown in the illustration.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.



4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)
Transmission
See page
R155
Click here
R155F
Click here
SST
09301-00210  


5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)
Transmission
See page
R155
Click here
R155F
Click here


6. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
Transmission
See page
R155
Click here
R155F
Click here


7. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
Transmission
See page
A340E
Click here
A340F
Click here


8. CHECK FOR ENGINE OIL LEAKAGE