Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for CrewMax)

NAVIGATION SYSTEM (for CrewMax) > Television Display Assembly Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component shown by the sub-code.

    HINT:
    1. "140 (navigation receiver)" is the component shown by sub-code in the example shown in the illustration.
    2. The sub-code will be indicated by its physical address.
    3. For the component list, refer to "DIAGNOSIS DISPLAY DETAILED DESCRIPTION" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit is operating normally, proceed to the next step.

    Component table 
    Component
    Proceed to
    Navigation receiver (140)
    Navigation receiver assembly power source circuit (Click here)
    Stereo component amplifier (440)
    Stereo component amplifier power source circuit (Click here)
    If the power source circuit is operating normally, proceed to the next step.


NEXT


3.CHECK NAVIGATION RECEIVER
E145834E02
  1. Disconnect the K18 and K8 receiver connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K18-5 (ATX+) - K18-15 (ATX-)
    Always
    60 to 80 Ω
    K8-9 (TXM+) - K8-10 (TXM-)

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A


4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "TERMINALS OF ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver and the component shown by the sub-code.

    1. Disconnect all connectors between the navigation receiver and the components shown by the sub-code.



  1. Check for an open or short in the AVC-LAN circuit between the navigation receiver and the component shown by the sub-code.

    OK:
    There is no open or short circuit.


    E145835E02



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER (Click here)

C
REPLACE NAVIGATION RECEIVER (Click here)
A

END