Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch

for Preparation Click here


DESCRIPTION

  1. If the AUTO UP/DOWN function does not operate, the cause may be one or more of the following:
  1. The ECU in the driver side motor determines that the driver side motor has not been initialized.
  2. The master switch has a malfunction.
  3. The Hall-IC in the driver side motor has a malfunction.
  4. The wiring between the master switch and the driver side motor is open or shorted.

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC B2311 is output
    B
    DTC B2312 is output
    C
    DTC B2313 is output
    D
    LIN communication system DTCs are output
    E



B
GO TO DTC (B2311) (Click here)

C
GO TO DTC (B2312) (Click here)

D
GO TO DTC (B2313) (Click here)

E
GO TO LIN COMMUNICATION SYSTEM (Click here)
A


2.CHECK MANUAL UP / DOWN FUNCTION
  1. Check that the manual UP/DOWN function using the master switch can operate the driver side power window (Click here).

    OK:
    Manual UP/DOWN function operates normally.



NG
GO TO FLOWCHART (DRIVER SIDE MOTOR CIRCUIT) (Click here)
OK


3.READ VALUE USING TECHSTREAM (MASTER SWITCH)
  1. Use the Data List to check if the master switch is functioning properly.

    Master Switch 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door P/W Auto SW
    Driver side power window auto UP/ DOWN switch signal / ON or OFF
    ON: Driver side switch operated
    OFF: Driver side switch not operated
    -

    OK:
    The Techstream display changes normally when master switch is operated.



NG
REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (Click here)
OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)