Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch assembly and information about the navigation antenna, and then adjusts the vehicle position.

WIRING DIAGRAM


E231120E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK VEHICLE SIGNAL


    E235191E04
  1. Enter the "Function Check/Setting I" mode and select "Vehicle Signal" (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever position.

    OK:
    Shift Lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual shift lever position.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK NAVIGATION RECEIVER ASSEMBLY


    E146425E19
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K6-5 (REV) - Body ground
    Ignition switch ON, shift lever in R
    11 to 14 V
    Ignition switch ON, shift lever in any position except R
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Navigation Receiver Assembly)
    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
Go to step 3
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
  1. Disconnect the D35 park/neutral position switch assembly connector.

  1. Disconnect the K6 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D35-1 (RL) - K6-5 (REV)
    Always
    Below 1 Ω
    D35-1 (RL) - Body ground
    Always
    10 kΩ or higher

    HINT:
    If replacing the park/neutral position switch assembly, refer to the procedures below.
    1. for AB60E (Click here)
    2. for AB60F (Click here)
    3. for A760E (Click here)
    4. for A760F (Click here)
    5. for A750E (Click here)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY