Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM (for SD)

DTC    B15C2    Speed Signal Malfunction

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a vehicle speed signal from the combination meter assembly and information about the navigation antenna, and then adjusts the vehicle position.
The navigation receiver assembly stores this DTC when the difference between the speed information that the navigation antenna receives and the SPD pulse received from the combination meter assembly becomes large.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


DTC Code
DTC Detection Condition
Trouble Area
B15C2
A difference between the GPS speed and SPD pulse is detected.
  1. Harness or connector
  2. Combination meter assembly
  3. Navigation receiver assembly

WIRING DIAGRAM


E231665E01


INSPECTION PROCEDURE

1.CHECK VEHICLE SENSOR (OPERATION CHECK)


    E176549
  1. Enter the "Function Check/Setting I" mode and select "GPS&Vehicle Sensors" (Click here).

  1. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are equal or almost equal.

    OK:
    The readings are equal or almost equal.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the K6 navigation receiver assembly connector.

  1. Disconnect the J28 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K6-3 (SPD) - J28-35 (+S)
    Always
    Below 1 Ω
    K6-3 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL)


    E190309E16
  1. Remove the combination meter assembly with the connectors still connected.

  1. Connect an oscilloscope to terminal J28-35 (+S) and body ground.

  1. Turn the ignition switch to ON.

  1. Check the signal waveform according to the conditions in the table below.
    Measurement Condition 
    Item
    Condition
    Terminal No. (Symbol)
    J28-35 (+S) - Body ground
    Tool Setting
    5 V/DIV., 20 ms./DIV.
    Condition
    Vehicle being driven at approximately 20 km/h (12 mph)

    OK:
    The waveform display is as shown in the illustration.

    HINT:
    When the system is functioning normally, one wheel revolution generates 4 pulses.
    As the vehicle speed increases, the width indicated by "A" in the illustration narrows.

    Text in Illustration 
    *a
    Component with harness connected
    (Combination Meter Assembly)
    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE COMBINATION METER ASSEMBLY (Click here)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)